Fall 2010 Workshop Schedule and Registration

Below are the driving directions to the Germanna Community College workshop. You may print this page by going to "File" and then "Print". When you are done viewing this information, you can Register For This Workshop or go back to the Workshop List using these links or the links below.

Workshop Information

Name	Germanna Community College Daniel Technology Center
Address	18121 Technology Dr. Culpeper, VA  22701
Website	http://www.germanna.edu
Date	Wednesday, September 22, 2010
Time	8:30 am - 12:00 noon

Workshop Notes

Registration Time: 8:30 am – 9:00 am
Workshop Time: 9:00 am – 12:00 noon

Driving Directions

Washington/Northern Virginia Areas (Interstate 95:
Take Interstate 95 S toward Richmond.
Take exit 130A, Rt. 3 W toward Culpeper.
Travel approximately 30 miles.
When you cross over U.S. 29, turn right onto McDevitt Drive and then turn right onto Technology Drive.
The Daniel Technology Center will be on the left.

Washington/Northern Virginia Areas (Interstate 66:
Take Interstate 66 W toward Vienna/Front Royal.
Take Rt. 29 S toward Gainsville/Warrenton.
Continue on Rt. 29 S to 2nd Culpeper exit.
Turn right onto Route 3 towards Culpeper.
Travel .5 miles to McDevitt Drive on right. Travel down McDevitt Drive less than half a mile.
Turn right on Technology Drive.
The Daniel Technology Center building is at the end of the road.

Richmond and other South/West Areas:
Take Interstate 95 N toward Washington DC.
Take exit 130B, Rte 3 W toward Culpeper. Drive approximately 30 miles.
When you cross over U.S. 29, turn right onto McDevitt Drive and then turn right onto Technology Drive.
The Daniel Technology Center building will be on the left.

Charlottesville Area:
Take Rt. 29 N toward Washington, DC.
Take Rt. 3 W toward Culpeper.
When you cross over U.S. 29, turn right onto McDevitt Drive and then turn right onto Technology Drive.
The Daniel Technology Center building will be on the left.

Parking is free.

 

Meeting Room: Conference Center Suite B

Options

Register For This Workshop

Back To Workshop List

---